Hệ thống đo mức mớn và két dằn tàu Model: BAL-2000/ Kiểu khí nén

Draft and Ballast Tank level measuring system Model: BAL-2000 / Pneumatic type

Draft and Ballast Tank level measuring system Model: BAL-2000 / Pneumatic type

Model: BAL-2000/ Pneumatic type

General introduction

The pneumatic level measurement system and ballast are designed to measure the level of ballast tanks, tangle levels, and fuel oil tanks of ships. The system uses sensors that measure gas thrust levels and is used to measure levels of different types of tanks.

Characteristics and features

Application

Structure and principle of operation of the system

The BAL-2000 includes an Air purge gas pusher, a dual brake valve, a payroll adjustment device, a direction adjustment valve, a gauge, and a similar display for each tank.

The principle of operation is based on measuring the hydrostatic pressure of the liquid by providing low constant air flow into the measuring tube, called the Sounding tube, at the outside below. When the air escapes through the mouth of the clean filter pipe at the bottom of the tank, the gas pressure corresponds to the level of liquid accumulated in the Sounding tube. If the specific weight (weight) of the known liquid and the pressure in the Sounding tube are measured, the distance from the pipe door to the surface can be calculated using the above expression. The pressure is read on the scale divided by the metric in meters or the volume or percent of the head of the tank.

Technical Specifications

Sensor typeAir thrust type ( PURGE)
Measuring range0 – 40m
Accuracy± 0.1% of F.S.
Signal pipeDiameter 8mm or 10mm
Ambient temperature-30 – 70 ◦C
Gas pressure4 – 7 bars

System structure

Tank level measuring system Model: BAL-2000/ Pneumatic type
Tank level measuring system Model: BAL-2000/ Pneumatic type

Related Post

Leave a Reply